Find a Conservatory Installer you can trust in Moffat.

The short and simple answer to this question is yes, just like other new extensions, you must have a foundation done for your lean to conservatory. In order to transfer the building’s weight to the floor safely, there’s a need to construct a foundation. Without it, the structural integrity of the extension would be heavily compromised. What’s more? While there’s no minimum depth requirement for a lean to conservatory, there are multiple factors that can affect the depth as well as type of the foundation. Let’s take a look!

• The nearby trees. What trees do is to absorb water from the soil which can affect the foundation significantly. When water is absorbed from the soil, the soil shrinks which affects the foundation’s strength. The size as well as type of the tree will determine the extent of the water absorption from the ground.
• The soil’s suitability. The weight that each soil can withstand varies and even more so, when environmental factors have more effect on certain types of soils than others. For instance, chalk is able to drain water away relatively easily which means that nearby trees will only have a little effect on its quality. Clay, on the other hand, shrinks when drying and also retains a lot of water. This means that nearby trees will have huge impact on clay soil which will compromise the structural integrity of the lean to conservatory. Therefore, since changes to clay mostly occur to about 0.75m depth, foundations on the soil should be constructed deeper to compensate.
• Undisturbed ground. Before the foundations are laid, there’s a need to identify grounds that hasn’t been built on and this usually takes a depth of about 1m (this figure may vary especially in regions where drains have been laid).

Many conservatories fall under permitted development which means they don’t require planning permission. There are exceptions to this though, especially if you’re looking to have a large conservatory installed. Read our guide on conservatory planning permission for more information.

If you’re worried about your conservatory being too hot in the summer and too cold in the winter, you can insulate it. Older conservatory roofs are made from inefficient polycarbonate, which means that up to 25% of all the heat lost in a conservatory escapes from the roof.

To insulate your conservatory roof, you can install blinds or curtains – but they can go mouldy from condensation. There are two other options that are more long-term that could be better: upgrading the polycarbonate in the roof or opting for a solid conservatory roof.

You can add a thicker polycarbonate roof panel with better thermal efficiency if the glazing bars on your conservatory will expand to fit. This will offer better insulation, but may not last very long – maybe less than 10 years.

A solid conservatory roof is a new way of making your conservatory usable all year round. Most existing conservatory frames will be able to support a lightweight metal structure and slate-like tiles to match your home’s roof. Or you can opt for a hybrid option where the solid and glass parts are merged together. This will insulate your conservatory roof so it never gets too hot or too cold.

When it comes to extending your home or creating more living space, you can either construct an extension, transform a current space or add a conservatory. While all the three available options to create more living space in your home are worth giving a shot, the wooden conservatory happens to be the easiest and cheapest of them all. If you are thinking about building wooden conservatory of your own, then you’d probably want to know exactly how much its going to cost. The simple answer is that it depends on multiple factors such as the type of wood required, the size, style as well as the quality of materials to be incorporated in your final conservatory design.

The most significant determinant, however, is the type of wood required. Below is a breakdown of the prices based on this factor:

• Hardwood Conservatory

Hardwood such as elm and beech are one of best options for building conservatories due to their complex structure which helps increase the durability and stability of conservatories. The price of an average hardwood conservatory without fitting usually ranges £10,000 to £15,000.

• Oak Conservatory

Due to its popularity and high availability, oak is a very common wood type used in the construction of conservatories. And as a result, it can be gotten within a range of £9,000 to £10,000 for just the wood. Oak can also be made to be resistant to bugs and pests. The price of this type of oak wooden conservatory jumps to around £15,000 to £20,000.

• Timber Conservatory

This refers to various types of wood that’s readily available before being subjected to treatment in different plants or factories. Due to its rather rough exterior and lack of a clean finish, this type of wood is usually gotten at a giveaway price. Depending on the type of wood, the price to buy just a timber conservatory kit can vary between £10,000 to £20,000.

Click here to learn more about wooden conservatories

Adding a lean to conservatory to your home or property comes with a whole lot of benefits. It provides you with the much needed additional living space within your property, add value to your home and creates a link between your home and garden. As advantageous as it is, one of the major concerns several homeowners have is whether or not is requires a planning permission. This is a crucial question that must be answered before you make financial commitment to the project. If you don’t know what you’re doing the entire process can be very tedious and you definitely do not want to go through the stress of completing your remarkable new conservatory, only to be instructed to have it removed again. In this post, we’re going to consider if obtaining a planning permission is required before adding a lean to conservatory to your property.

Generally, adding a lean to conservatory to a property is considered to be a “Permitted Development, which implies that you won’t have to apply for a planning permission to complete the project without any risk of interruption from the appropriate authorities. However, there certain circumstance that’ll require a planning permission. These circumstances include:

• If the conservatory covers more than 50 percent of the land around the main house.
• If the conservatory will be placed on the side of the house that faces the road.
• If the conservatory will be higher than the highest point of the main building’s roof.
• If the main building is lower than the height of the eaves and ridge.
• If the conservatory will be constructed to the side of the house and more than a single storey or it goes higher than 4 metres.
• If the conservatory will be wider than the width of the main building, if it’s to be built beside it.
• If the conservatory will be constructed at the rear and higher than 4 metres.

With the ability of orangeries to create additional space in your home as well as altering the appearance of your property completely, it’s very likely you’ll require a planning permission to construct an orangery. However, with the lengthy and complicated application process, you might want to consider the few exemptions before getting started.

If you’re considering to build an home extension such as an orangery, the obvious first step would be to consider whether or not you’ll need planning permission. And while you tend to get carried away in the thought of adding new beautiful living space, you should never forget to take into account your area’s planning regulation as well as the planning process realities. However, the application process is not one of the most exciting activities any homeowner would like to pass through and even more so when they live in a conservation area or possess a listed property that can even make the process a lot more challenging.

It’s recommended that you consult your plans and ideas with a professional such as an architect, building design company or a chartered surveyor, but there are some options you can put into consideration if you want to avoid the applying for a planning permission.

If you’re sure about not wanting to apply for a planning permission, you’d have to check your area to identify the possible local planning implications and determine whether or not your home has permitted development right which allows for some building works that can be made without the need to apply for a planning permission. To do this, simply check the government’s planning portal to determine whether your project is covered by the permitted development rights or applying for a planning permission would be required. What’s more? You need to determine if your building is listed especially if you live in a period property. For listed building, it can be much more difficult to get a planning permission as you must comply with some very specific regulations.

First and foremost, a conservatory or a sunroom is a structure attached to the sunny part of a house which possess glass walls and roof which enables the sun’s entrance into the space. Conservatories happen to be a very popular structure in the UK as home and property owners are able to subject it to wide variety of uses such for relaxation, entertainment, hangouts with family and friends, reading and lots more. Therefore, when the conservatory roof is leaking a lot of activities could be affected. Hence, the more reason why you should know hoe to repair this kind of issue by yourself. However, if you’re not confident enough to carry out this task, we’ll recommend you call in a professional who can guarantee the best output the first time. In this guide, we’re going to look at the conservatory roof leak repair process.

• Spot the leak. The first line of action is to examine the conservatory’s roof to identify the leaking part (tip - most leaks takes place around transparent roof panes edges). If you have a slanted roof, you’d have to look carefully. The spot where it drips may not necessary imply that its the leaking spot.
• Remove the old seal. Climb a ladder to access the leaking pane. Then, with the help of a utility knife, lift out the panel and clean all traces of the old sealant. Once done, simply lay down a bead of the new sealant in the frame, press the clear panel back in place and apply sealant to the outer edges.
• Cracked pane. If the existing pane is cracked or broken, simply hold the pieces tightly together by applying tape across the pane in various directions
• Leak sealing. Another option to fix leaks is by applying a sealant around the leaking pane without having to remove it.

How To Tile Conservatory Roof

If you’re thinking about replacing your old conservatory roof with a tiled one, you’d probably want to know how you can go about it. Tiling of a conservatory roof comes with a plethora of benefits with the most significant one being a much improved insulation which helps you save money on heating bills. This activity is also, however, a task that is best done by a professional. It requires working at height which can be very dangerous and also demands a particular set of skills as well as confidence to make the project a safe and successful one. In other words, if you lack any of the aforementioned attributes, then we’d strongly recommend that you call in a reliable professional who can guarantee the best results for help. In this article, we’ll walk you through the conservatory roof tiling process.

✓ Remove the existing roof. As you would have guessed, the first step is to remove the old existing roof and dispose off in an environmental friendly way.

✓ Glass Reinforced Plastic (GRP) rafters are fitted so as to develop the structural frame for the new solid roof.

✓ Waterproofing. The next step is to add 100% waterproof sheets under the GRP rafters.

✓ Insulation. Once the waterproof sheets have been installed, it’s then time to fit the insulation boards making sure that there’s a 15mm gap between the boards and the waterproof sheets.

✓ Outer sheets. To minimize the number of roofing bars and increase the conservatory’s efficiency, you’ll have to include the outer sheets at this stage.

✓ Tiling. This is the final step in the process. Add the tiles to the conservatory roof and make sure that they’re firmly secured. This wouldn’t take forever as most conservatories are not that big in size.