Find a Conservatory Installer you can trust in Melton Constable.

In 2002 the Government amended Building Regulations governing the replacement and installation of glazing units. For the first time, windows had to meet energy efficiency standards and tough thermal performance levels. For new window units you must have efficiency ratings of at least a level C.

Generally, if you want to do a job, you can as well ensure that’s done properly. You may be considering building a small base for an orangery, but no matter how small it is, it just shouldn’t be done to any other than a compliant standard, and that’s whether or not an approval is needed. When it comes to building work which is covered by Building Regulations, you are required to comply (by the law) with the regulations and to make use of one of the two types of Building Control Service available. These includes the Building Control Service given by your local authority or the Building Control Service given by approved inspectors.

Regardless of the service you opt for, you’re going to pay but the preferred service may offer an advice before commencement of the project. The individual carrying out the building work is charged with the responsibility of ensuring total compliance with the regulations. Therefore, if you select to undertake the project by yourself, the responsibility is primarily on you. In the same vein, if you opt for a building company the responsibility would be the company’s, but you should always ensure to confirm this position before commencement of the project. You must also take note that you may be served with an enforcement notice if you fail to comply with the regulations as the owner of the building. So it’s advisable that you choose your builder very carefully.

There are a bunch of elements you may require approval for like the structural integrity, appropriate insulation levels, or the construction of a building over drainage or sewage. In cases where it’s obvious that you’d need building regulations, you can simply submit the building and planning application together at once.

If you’re worried about your conservatory being too hot in the summer and too cold in the winter, you can insulate it. Older conservatory roofs are made from inefficient polycarbonate, which means that up to 25% of all the heat lost in a conservatory escapes from the roof.

To insulate your conservatory roof, you can install blinds or curtains – but they can go mouldy from condensation. There are two other options that are more long-term that could be better: upgrading the polycarbonate in the roof or opting for a solid conservatory roof.

You can add a thicker polycarbonate roof panel with better thermal efficiency if the glazing bars on your conservatory will expand to fit. This will offer better insulation, but may not last very long – maybe less than 10 years.

A solid conservatory roof is a new way of making your conservatory usable all year round. Most existing conservatory frames will be able to support a lightweight metal structure and slate-like tiles to match your home’s roof. Or you can opt for a hybrid option where the solid and glass parts are merged together. This will insulate your conservatory roof so it never gets too hot or too cold.

When people talk about finishes on a wooden conservatory, there are a few different things that they may be referring to. Some may be referring to the colour and type of wood used to build the conservatory, but they may also be talking about the type of treatment used to protect the wood from the weather. We’ll cover both bases for what finish is best on a wooden conservatory here.

When you’re thinking about the best wood type and finish for the conservatory, it’s best to go with a hardwood. There are both hardwoods and softwoods, and hardwoods are the most durable. Oak is the most expensive choice but is also the most durable, so lots of people decide to go for this option. Other good choices that are slightly cheaper are Brazilian cedar and idigbo. Softwoods like European redwood or Siberian larch are cheaper still, but they won’t last as long, so it may work out more cost-effective to spend more on a hardwood.

Wood is a natural material, so it’s important to look after your wooden conservatory to prevent it from rotting or getting attacked by bugs and pests. Your conservatory will be exposed to all weathers, so you’ll need to use a good finish to ensure that it stays in tip-top condition for years to come. Your installer should be able to tell you what’s best, but some of the best finishes for a wooden conservatory include breathable varnishes and decking oil. However, if you do use an oil, it’s best to use a preservative treatment too; oil will only repel water. Joints are particularly susceptible to water penetration, so make sure you use a good wood treatment and focus on areas where water would pool during rain. Then you can apply a decking oil afterwards.

• The rules only apply to houses – flats and maisonettes are not included
• Only 50% of the area of land around the original house can be covered by extensions, including conservatories, and other buildings
• You mustn’t build the conservatory higher than the highest part of the original roof
• Where the wooden conservatory comes within 2 metres of the boundary, the height at the eaves can’t exceed 3 metres
• A rear wooden conservatory can’t extend beyond the rear wall of the original house by more than 4 metres if it’s a detached house, or more than 3 metres for any other type of house
• For side extensions, for example a lean-to wooden conservatory, it can’t exceed 4 metres in height and can only be up to half the width of the original house

Conservatories have long been a favourite home improvement with homeowners, and there are no signs of that trend going away. And because of that, they add value to homes.

Wooden conservatories add value to your home just as any other type would. In fact, in some cases a wooden conservatory will add more value to your property than a uPVC or aluminium one, for example if your home is a period property. A wooden conservatory will fit in keeping with the rest of an older property, so buyers will prefer a period home with a wood conservatory over a uPVC one.

It’s important to remember that wooden conservatories cost more than uPVC ones, but that does mean that they will add more value. They look more stylish than uPVC conservatories and may last just as long with the right care and maintenance, so if a wooden conservatory would complement your home much more than uPVC they’re worth looking into.

A wooden conservatory will set you back anywhere between £25,000 to £60,000, so factor this in when you’re thinking about how much value it will add to your home. It’s also worth thinking about the other things that will have an impact on the value it will add to your home, such your property’s location, whether conservatories are a common addition to houses in your area, the general look of your home and whether the conservatory would take up a large part of your garden. If you’re unsure whether a wooden conservatory will add enough value to your home, you could speak to a surveyor or valuer to give you their opinion before you start any work.

When you build a new wood-constructed conservatory, or any type of conservatory, you’ll need to dig a trench for the footings. You’ll need to dig to a minimum depth of 600mm and at least 300mm below your property’s damp proof course. When you dig down, you might expose obstacles such as underground pipes.

If this happens, you’ll need lintels for your wood-constructed conservatory. These are usually concrete and protect the pipes or obstructions from being crushed. You may also want to use steel mesh for additional support.

Building Regulations state that if an opening is formed in a wall, the structure above the opening needs to be supported. This will be especially relevant if you’re building a wooden lean-to conservatory. It says that there are two ways that you can use lintels to provide support.

The first way involves using a steel lintel to support both the inner and outer leaf of a cavity wall. It can then serve as a cavity tray that directs moisture from the cavity through the outer skin of the wall as well.

The second way to use lintels is to use two steel or concrete lintels. They support each leaf of a cavity wall construction. You’ll need separate thermal insulation and a cavity tray as well.

Whatever type of lintel you use, it should have a suitable bearing onto the wall at each side. If you’re not sure, speak to the manufacturer of your wood-constructed conservatory, or ask a reputable company to install it for you.