Find a Shop Fitter you can trust in East Midlands.

Soffits and fascias sit along the sides of your property, over the join between your walls and your roof. The fascia attaches to the end of your roof rafters, hiding and protecting them. The soffit fixes on the bottom of the fascia, bridging the gap between your fascia and wall. Your guttering attaches to the fascia, which also joins to the bargeboard on your gable end, if you have one.

1. If you’ve not got an overhang or it’s a fixed deck, fit starter clips along the outside edge of the frame and secure with screws provided with the composite decking. If you are working with an overhang, put the first board into position not exceeding 25mm. If you’re adding a fascia, put an off-cut of board under the overhang so you know it’ll be flush with the fascia.
2. Pre-drill all fixing points, measuring in 30mm from the edge of the board. Secure the board to the joist below with composite decking screws.
3. Slide a hidden fastener clip in so it sits within the groove of the deck board. It needs to be in the centre of the joist to keep the boards secure and ensure an expansion gap of 6mm. Tighten the clips until just tight, and repeat so there’s a clip at every joist.
4. Add the next board, ensuring that the fastener clips sit within the groove – make sure you don’t force it. Repeat step 3.
5. Continue steps 3 and 4 until you’re at the final board, which you should secure in the same way as you did the first.

Who Fixes Boilers?

With boiler running for several hours in a day and working hard to ensure that our home stays warm, even when we tend to take it for granted it’s always there give us the heat we need whenever we need it. So in the event whereby the inevitable happens and your boiler breakdown, which professional is the most suitable to call for help? When the pressure is on to stop a boiler leak or bring back warmth to your home, knowing who to call can make all the difference.

When you need a professional to fix your boiler, the right professional to call is a heating engineer. Heating engineers work mainly on heating I both homes and businesses, so you’d be right to call them specialists in all heating matters. As a result of this, you may want to give them a call when experiencing some issues with your boiler as they’d be in the best position than any other professional to give you a proper solution.

Generally, heating engineers are experts when it comes to fixing boilers and can help with various tasks such as installing a new boiler, boiler repairs, installing new gas pipes, repairing gas leaks, changing radiators, fixing leaks, installing heating controls and many more. What’s more? A boiler repair has to do with working with gas and before you can do that you must be a Gas Safe registered engineer as required by the legislations in the UK. In other words, any gas boiler related issue must be tackled by a Gas Safe registered engineer as this is a very dangerous fuel in which the services must be provided to highest standards of safety. Only heating engineers can be a Gas Safe registered engineer to work on gas boilers.

What Is The Best Material For A Conservatory Roof?

In the past, conservatories normally have just a single roof material option - polycarbonate. However, there are a number of problems that was faced by some of the older models such as overheating, leaking roof, cold spots as well as poor sound insulation. With the great improvement in conservatory roof technology, better models have been developed which have completely eradicated these issues.

In recent times, we now have a wider varieties of materials that are incorporated to make conservatory roofs which are able to perform much better for a longer period of time. While tiled roof are incredibly useful to minimize heat loss, glass roof make use of clever reflective coating to keep the space at a comfortable temperature and modern polycarbonate roofs are now more energy efficient than it has ever been. So picking the best material for your conservatory roof is now a matter of preference.

✓ Glass conservatory roofs. This type of conservatory roof material is the perfect choice if you want a sleek, architectural finish for your conservatory. Not only are they available indifferent shapes and sizes, but you can also choose a large atrium style roof. They are made using solid aluminium frames that works to support the glass units which are thermally efficient and designed to retain natural heat while reflecting the sun’s glare.

✓ Tiled conservatory roof. Tiles roof are able to fit both the shape and size of your conservatory which provides you with a sloping or vaulted ceiling. They come in varying tiled finishes to match any style home like Marley clay, slate grey, pale shingles amongst others. Tiled roof are also called “warm roofs due to their particularly high levels of thermal insulation. They can also be installed quite easily and as quickly as any other conservatory roof options.

Are Electric Radiators Expensive To Run?

Just like many home additions, the running costs of electric radiators varies largely on a number of factors. Great number of electric radiators typically comes with an in built thermostat which is designed to turn itself off automatically when not in use in order to save energy.

However the energy provider’s set electricity charge tariff will also have a great influence on an electric radiator’s running cost. Let’s take a look at the running costs of an electric radiator!

A 600 Watt electric radiator ( on a standard electricity tariff) will usually have a running cost ranging between 4 to 6 pence each hour. However you should also take note that this scenario might change in situations whereby the electric radiator is not calling for heat the full 60 minutes of each hour. And this is more likely to be the situation as the thermostat is programmed in such a way that enables it to turn itself off immediately there’s an achievement of your required room temperature level - usually within 10 minutes from the time it was switched on. As a result of this, the running cost per hour of electric radiators will be greatly reduced to just about 1 to 2 pence.

It’s also important to note that enhancing the insulation of your home can go a long way to add to the heat retention value of each room. Consequently, the duration at which the electric radiator calls more heating will be significantly reduced, which in turn, implies a lower electricity bill.

Another key factor that can play a huge role in saving on your heating bills is the programming as well as usage of your electric radiators. Every radiator comes with an independent digital thermostat with a number of 24/7 programming options to help achieve maximum efficiency. When the radiator is properly set according to your lifestyle, you can save as much as 50 percent on your heating bills.

Commercial architects can produce plans and technical drawings as well as offering advice and assistance to help you achieve your desired goal. They will also put a creative spin on your building project – perfect for retail or office buildings. Commercial architects will make your building stand out from the crowd!

You might think that all wooden conservatories are the same. But there are actually lots of differences between them, and some conservatories are better than others. One of the most important factors to consider when you’re looking for a wooden conservatory is the type of wood that it’s made from. Generally, there are two different types to look out for: softwood and hardwood. So what wood should be used for a wooden conservatory?

Softwood conservatories are usually made from European redwood or Siberian larch. These types of conservatories are the cheapest wooden conservatories you can buy because the wood grows much faster than hardwoods. However, due to their soft nature, they may only last 7-15 years, reducing their cost-effectivity.

The best wood to use for a wooden conservatory is a hardwood. The most expensive type is oak, but you get what you pay for – it looks fabulous and it can also be coated with a bug and pest-resistant solution to increase its longevity. If you haven’t got the budget for oak, other hardwood options include Brazilian cedar, idigbo and luan, which are still great choices. Make sure you speak to your conservatory installer about the ‘closeness’ of the wood grains, as close-grained hardwoods are said to be the most suitable for conservatories. You should also check that your supplier has strict control of the quality of the wood so can ensure that it’s been well seasoned and prepared for use in construction.

Damp issues on a property are usually generated by a lot of factors such as a poor or broken guttering, condensation and lots more. The question arising here is what is the possibility of External Wall Insulation (EWI) preventing condensation? Not only is EWI a reliable way to reduce condensation-caused damp, but it’s also one of the major reasons property owners in solid wall homes consider thermally rendering or cladding their external walls.

Condensation arises as a result of warm moist internal air hitting a cold surface such as the steaming up of both windows and mirror when having a shower. What happens here is the condensation of the water vapour in the air from a gas to liquid in the process of touching the cold surface - one whose temperature is significantly reduced to reach the dew point. At the dew point, condensation is very rampant, and to tackle this issue you’ll have to heighten the wall temperature in order to convert the moisture to vapour and permit it to pass through the wall. And that’s exactly the job of an external wall insulation!

To get started you must ensure that the walls are clean and dry prior to fitting the external wall insulation. The month of May through to September when the weather tends to be dry and more stable are usually the best period to carry out the project. The external wall insulation will function just like a cosy blanket around the building. Ultimately, changing the feel and temperature of the inside of your home. As a result, the previously cold walls will no longer be cold which goes a long way to mitigate the effects of condensation. Furthermore, when an EWI is installed, the rooms of your home will automatically trap more thermal mass as the heat is saved in the walls’ fabric and released back when the temperature drops.