Find a Shop Fitter you can trust in Inner Hebrides.

How To Remove Tile From Wall

Have you stumbled on some stylish new tiles you wish to install in your home, be it bathroom, kitchen or living room? Or perhaps you just feel your old tiles have outstayed their welcome and need a to install a more modern and appealing wall tile. The first step before installation of the new tiles will be to remove the old ones which can be done by following these simple steps below:

lSafety

• To remove wall tiles, you’d have to chip them away and that implies shards of porcelain, ceramic or glass flying around. Hence, your safety should be a top priority.

• Use safety goggles and protective gloves to protect both your eyes and hands.

lCover Up

• With several sharp objects flying everywhere, all objects in the room are far from safe.

• Use a cardboard or old sheet to protect the room and valuable objects from damage.

lAssemble The Tools

• For wall tiles removal, you need just two tools - a hammer and a chisel that’s a bit thin.

• In the event whereby a chisel is not available, you can make use of a flat headed and large screwdriver.

lGet To Work

• Feel for a loose tile to start with and if successful, chip it out with a chisel.

• If you can’t find a loose tile, then break one by sticking the centre of a tile with a chisel and hit it hard with a hammer.

lRemove All Tiles

• Once you’ve been able to chip away or break the first tile, you can easily get access to other tiles.

lClean Up

• Try to get as much dried adhesive off the wall as you can by gently tapping it with the chisel and hammer so as not to damage the wall.

• Once done, put away the cardboard and dust sheet which should have collected much debris.

• Use a brush and dust pan to clean out the loose pieces (if any).

Wall tiles removal can be a very dangerous process which should be left to a professional especially if you lack a proper training or experience. This is not only to prevent anybody being hurt, but also to avoid any possible damages to the wall or any valuable object which can result in additional cost on repair or replacement.

Underfloor heating are very commonly incorporated in new builds as the main source of central heating. They are also growing to become more popular alternative when compared to the traditional radiators. This increase in acceptance is caused partially due to the fact that underfloor heating can be fitted under almost all types of floors which includes tiles, wood, stone and carpets. If you’re looking to have underfloor heating installed in your home, then one of the first things you’d probably want to consider is the cost of making such an investment. If yes, then you’ve come to the right place! In this post, we’re going to shed some light on underfloor heating pricing to help you make informed purchase decisions moving forward. Let’s take a look!

First and foremost, you should know there are two main types of underfloor heating. These includes electric or dry system and water or wet system. Generally, electric system are less costly due to the fact that they’re relatively easy to install ( making them more suited for retrofits to existing properties ) while a water system installation requires a lot more efforts ( which makes it usually preferred for new builds or as part of a larger renovation project). therefore, if you’re considering getting a water underfloor heating system which will be connected to your central heating, then there’s a need to get a reliable and professional local plumber.

Generally, a wet system will usually cost within the range of £5000 to about £7000 to be fitted in a new build or a larger renovation project. Meanwhile, a installing a dry system is always cheaper. This starts anywhere from £170 for 10 square metres.

How To Dot And Dab A Plasterboard

If you want a fast and simple way to achieve a smooth and sturdy wall which is decoration-ready, then dot and dab plasterboard is the way to go! It’s a relative simple process but can also be a bit challenging. Therefore, if you lack the necessary training or experience, hiring a professional would be a great step to protect your investment and guarantee the best results. Here, we’ll provide you with a deep insight into the plasterboard’s dot and dab procedures. Let’s have a look!

• At the thickness of the board with the adhesive, mark the ceiling and floor as well as the wall to indicate the centre of each board.

• Ensure the wall’s height is 15mm more than the plasterboard

• Make a mixture of the adhesive and achieve a thick consistency. Apply a consistent layer of the mixture around the wall’s perimeter, edge of the ceiling and any other openings with the use of a trowel.

• Select dabs that are about 250mm long and 50mm to 75mm wide and apply the adhesive in them. Make use of 3 vertical rows for individual boards. Also ensure to apply, at skirting level, a band of adhesive.

• Position the board’s reverse side against the dabs, and laying against the packers. Then make the board align with the ceiling and floor marks with the help of a straight edge.

• Raise the board till its tight against the ceiling with a board lifter. Once done, use the plasterboard to wedge the board into place before you remove the board lifter.

• Repeat the same process for the remaining parts of the room. Once completed, make sure the adhesive is set before you remove the boards.

Orangeries are being built by thousands in the country year in year out and for good reasons. Not only do they provide a cost effective alternative to moving home and boosting your property’s value, but can also be used all year round. If you’re looking for a room for all seasons, then you simply would not want to overlook building an orangery. They can be quite cosy in the winter months protecting you from the wind and rain, and keeping you warm, while you can throw the doors and windows to enjoy the sunshine during the summer months.

Orangeries can be used all year long as they’re made mostly of components which makes them stay warm all through the year, which is unlike conservatories that’s almost wholly made of glass meaning they are not suitable to be used during the colder months. This implies that orangeries can be used for almost any purpose throughout the year regardless of the time of year it is. What’s more? With a plethora of style and options of orangeries you can choose from, there’s hardly any space you can’t fit an orangery, be it small or large. In recent times, more and more homeowners are now using their orangeries for a variety of purposes such as game rooms, chill out area, lounges as well as dining rooms. They have this special ability to create a seamless transition from your home to your garden while also allowing you to alter the room’s layout all year round depending on your needs at the time.

How Much Is A Conservatory Roof?

If you’re setting a budget for your new conservatory structure or perhaps you already have one and thinking about replacing the roof, knowing how much a new conservatory roof will cost from the onset can save you a lot of headache. However, knowing the correct cost won’t be easy as this is determined by a plethora of factors which is unique to each individual. In this article, we’re going to give a rough estimate of a conservatory roof cost so as to help you make an informed decision moving forward. Let’s have a look!

In order to determine the cost of your conservatory roof, the type of roof you go for must firstly be determined. This is because there is a wide array of conservatory roof types with each having its own unique price. You can opt for the uPVC glass roof, a tiled roof or a glass roof.

With so many other factors to consider, we’ll not be able to give you an exact amount. However, in general, a conservatory roof can cost anywhere within the range of £2500 to £8500. You may also quoted for more or less depending on your roof type as well as the specifications you opt for including the size and type of your conservatory. For instance, if you own a Lean-To conservatory with a size of 3.1m by 3.1m, for a glass conservatory roof, you can expect to spend anywhere within the range of £3000 to £3500. Meanwhile for a Victorian conservatory roof with a size of 5.1m by 5.1m, the cost will range between £5000 to £8000.

Therefore the type as well as size of your conservatory really does greatly impacts the cost of your conservatory roof.

By replacing the single glazed windows in your home you stand to make savings of around £170 each year. It’s not just the financial gain that makes double glazing attractive though and you can also save up to 680kg of carbon emissions annually. Over 20 years this is a saving of around £3,400 and 13,600kg of CO2.