Find a Shop Fitter you can trust in Tenterden.

Yes, it’s a dirty job, but every homeowner out there has got to do it! Your gutter needs to be free of dead leaves, birds’ nest and other debris as well as being through clean in order to perform its functions effectively. It’s just a part of the responsibilities that comes with owning a home. Dry leaves, tree branches and other materials build up in your gutters overtime especially during the dry summer and you won’t notice until the point where your gutters start overflowing during the first main rain of the season.

In the event whereby your dirty and clogged gutter is left unattended to, this can lead to several issues like a leaky gutter and mold, leaky roof and basements,cracked foundation, driveway and yard damage and several more which will definitely make you incur more unnecessary expenses. So the question is, how often should the gutters be cleaned? The answer is, it depends. According to several experts, gutters should be cleaned at least twice a year - which is once in the late spring and once in the late summer or early fall. However, there are a couple of factors that may make you have a rethink.

If you happen to have a pine tree growing above your house, it’ll be wise to consider inspecting your gutters every 3 months. This is because pine trees shed needles year-round and they usually have a lot of these needles to shed. In the situation whereby you’re located at a higher elevation, ice is will most likely be your greatest source of concern. Making sure that your gutters remain clean throughout the winter can be quite a headache, but damage to your roof cause by ice can be an even greater pain. Prevention is always better than cure.

1. Hang a plumb bob from the outlet to the drain to use as a guide while you draw several marks on the wall with a pencil to show you where the downpipe will run.
2. Join the marks up with a straight edge, creating a line to show where the centre of the downpipe will be.
3. Position a downpipe clip at the top of wall, in the centre of the pencil line. Mark the position of its fixing holes on the wall. If you need an offset bend, put a downpipe clip directly below the bend.
4. Repeat the process down the wall. Make sure there is no more than 1.8 metres between pipe clips.
5. Refer to the guttering manufacturer’s instructions to see which drill bit is required. Use a drill to drill the fixing holes and insert wall plugs.
6. Fit the first piece of downpipe starting from the outlet and moving towards the drain.
7. If you need to add more downpipe, join the two pieces with a pipe socket and clip. Leave a 10mm gap between the end of the pipe and the bottom of the pipe socket, because it will probably expand. Then attach a pipe clip over the joint.
8. Continue attaching pipe clips down the length of the downpipe.
9. If you need to, fit a downpipe show to direct the water into the drain. Attach a downpipe clip directly below the socket of the shoe.

Yes. Modern condensing oil boilers are ‘A’ rated and therefore as efficient as comparable gas boilers. They come with the same controls as gas central heating systems, so you can still use a thermostat to control your heating efficiently. Also, oil is more efficient as a fuel source than gas, so you will get more energy per unit of oil. Oil prices can fluctuate, however, so ensure that you find a good supplier.

Do You Need A Building Reg For A Conservatory?

If you’re planning to build a conservatory in your home, it’s only logical to consider whether or not you require a building reg for such a structure. Generally, several conservatories, summer buildings, sheds as well as outbuildings do not require building regulation approval to erect. One of the applicable rules is the fact that if they’re ( small or less than 30m2) or constructed with non combustible material, or are differentiated from structures nearby or land and don’t feature sleeping accommodation or room, then they’re not required to submit a building regulations approval application. However, it’s strongly recommended to check with your local authority before you commence the project as only they can provide the most accurate information.

Generally, conservatories should be primarily built of translucent walls and roofs, while also possessing an external type door separating them from the main building within a property. What’s more? The foundations and floors, however, can be laid in a number of ways, but you’ll have to put into consideration the conditions of the ground, trees as well as the existing drains. It’s also a wise decision to include insulation which makes the structure a lot easier to heat especially during the cold months.

Overall, conservatories are usually exempt from building regulations if the following conditions are met:

✓ If the conservatory is erected at ground level and are not up to 30 square metres in floor area.

✓ If the structure is separated from the rest of the house with an external quality walls, windows or doors

✓ If the conservatory features an independent heating system with different temperature as well as on/off controls

✓ If the glazing and electrical installations are in total compliancewith the relevant regulatory requirements.

Unfortunately, you can’t fix the glass on one side of a double glazed window. That’s because they’re sealed units – once one pane of glass is broken, that will break the seal and its thermal insulation properties will be lost.

The good news is that if your window frame is still looking great, there’s no need to replace that. You can simply replace the glass in the window, which will cost much less. You can look to spend around £250 on a sealed unit, whereas a whole replacement single window may cost up to £600.

When an installer comes to replace the glass in your double glazed window, they will survey the inside and outside of your home around the window, then move any furniture by the window so they’ve got access. They should then pop a dust sheet down to stop any debris from getting on your floor.

Then, the installer will carefully remove the beads from the frame. They will then lift the glass out of the frame and put it somewhere safe before cleaning out all of the dust and any debris that has found its way into the frame. Using spacers at the bottom of the frame, the installer will make sure that the sealed unit is square in the frame to get a good fit. Once they’re happy, they will replace the beading and make sure it looks perfect before cleaning up their tools.

You could have a go at replacing the glass on a double glazed window yourself, but it’s not recommended. Leave it to the professionals who will know exactly what to do and will be able to do it quickly and safely.

Not always is the answer, unfortunately many of the products sold for household use by untrained professionals may not get rid of all the fleas in your home. If some fleas are left they will reproduce and you will end up with a flea infestation again.

If you just bought a Smart TV and you’re not certain whether or not you’ll need to purchase an aerial to be able to access your favorite TV channels, then you’ve come to the right place! So many Smart TV owners also face the same issue and seek an effective solution to it. In this post, we aim to provide you with an insight on this topic to help you make the best-informed decision possible moving forward. Let’s take a look!

The short and simple answer to this question is no, you don’t have to buy a TV aerial to watch your smart TV. However, it should also be noted that you won’t be able to access Freeview or any other terrestrial broadcasts for that matter without a TV aerial. What’s more? You’ll also be restricted to the content offered by your television’s internet streaming app. To unlock Freeview channels, you can consider purchasing an affordable and portable indoor aerial for that purpose. So, what can you watch on your Smart TV without an aerial? Well, without a TV aerial, you’ll only be able to access mod boxes or media from other sources like Blu Ray players, gaming consoles, computers and more. In the event whereby your Smart TV is connected to the internet as it’s designed to be, you can also make use of a plethora of streaming apps to access plenty of media online.

If you don’t want to watch you TV with an aerial, the best option would definitely be to connect your router or broadband through an ethernet cable and make use of the featured streaming apps.

We all know how helpful air conditioning systems can be especially during the hot summer season which is great at making your home feel nothing less than an inferno. So if you have an AC system, you’d probably want to know if leaving it on will be cheaper and more efficient.

The short and simple answer to this question is yes, leaving your air conditioning system on will make make it cheaper and more efficient. This isn’t what you or many other people will have in mind though. Under no circumstances should you leave you air conditioning system on full blast 24/7. To make your air conditioning system more efficient by leaving it on has a right and wrong way you can go about it. Let’s have a look!

If you’d ever noticed, any time you turn your air conditioner off during a very a hot day, even if it’s for just a couple of hours, things tend to get thrown out of balance pretty quickly. When turned back on, your AC system will have to work even harder to restore the usual comfort levels in the room. When you abuse this dial in such a fashion, the AC system can only become more inefficient rather than making your home more comfortable quickly.

On the other hand, your AC system ( when tuned to the right settings) can help maintain the proper temperature and humidity balance within your home instead of turning it off while away. And upon getting back, you can simply turn down the thermostat a bit which helps you prevent the usual stagnant air that you’d be hit with when your return home (with the AC system turned off) that’ll have you racing for the dial.