Find a Shop Fitter you can trust in Donaghadee.

Doors can be bought in a range of materials, such as wood, aluminium or uPVC. There are also more modern composite doors which use a variety of different materials for toughness and durability. Doors are also available in glass reinforced plastic (GRP), and engineered timber.

A boiler is simply the most important part of a central heating system as it generates the heat that warms up the home or property. Basically, the appliance or small furnace makes use of gas, LPG or oil in order to fuel its operation. However in the UK, most boilers are usually fuelled by natural gas which is supplied automatically from the national gas grid. And depending on how it operates, there are various types of boilers.

Typically, a gas central heating boiler will have multiple pipes entering from underneath. While one pipe supplies the boiler with gas from the mains gas supply, another pipe allows cold water to enter the boiler to be heated, the last pipe then enables hot water to exit the boiler so it can be distributed around the home.

✓ There are fuel jets and heat exchangers inside the boiler. When the heating is turned on, a valve is opened to allow the mains supply gas to enter a sealed combustion chamber in the boiler. There are multiple little valves which permit the entry of the gas before being ignited by an electric ignition switch. These jets heat a metal component in the boiler known as a heat exchanger which works to transfer the heat to the cold water pipe and heat up the water.

✓ Once the water has been heated to the target temperature, it’s then pumped through a circuit of pipe which runs around your home by an electric pump.

✓ The heated water enter each radiator, is then transmitted via a closed loop and radiates heat into each room.

✓ Once done travelling through all radiators, the water then returns to the boiler at which it must have been cooled. Therefore, the boiler will have to reheat following the same process before circulating. The water can only be drained by a professional Gas Safe engineer

How Much Do Painters And Decorators Charge?

If you’re thinking about painting your home or property, then one of the first things that crosses the mind is the amount charged by painter or decorators to carry out the project. However just like any other home improvement projects and as with most tradesmen, the amount charged by a painter and decorator largely varies from job to job depending on a plethora of factors. These factors include your location, the urgency at which you need the job done and whether or not a specialist equipment would be required.

For painters and decorators, one of the biggest influencing factors that determines the price to be charged is the size of the room. For instance, if you have a large room to be painted, it’s definitely going to cost you more than a smaller room. And same applies to multiple rooms when compared to single room. In other words, to get a more accurate cost estimate from your tradesman, you’ll need to have a good idea of the size of your room or rooms. So let’s take a closer look!

✓ Painting a mid-sized room. The question here is, how do you know if your room is medium sized? The room will have a size of about 3.5m by 5m or a room that can conveniently allow up to 6 to 8 people. The price range is between £240 to £410.

✓ Wallpapering a mid-sized room. This uses the logic as painting a mid-sized room but the price can differ due to difference in materials used. The price range here is between £204 to £420.

✓ Painting a large ceiling. Painting a ceiling is very similar to painting a wall but its not as straightforward and will consume more time. The price ranges from £286 to £5476.

What Is A Gas Safety Certificate?

Do you wish to know what a Gas Safety Certificate is and if you need to get one?

If you’re in the UK and you own a rental property, you have a statutory obligation to obtain a Gas Safety Certificate. The law ( Gas Safety - Installation and Use, Regulations 1998) stipulates that landlords as a matter of necessity should have all their gas appliances, fittings,and property flues subjected to yearly checks in order to ensure that they’re are totally safe.

The Gas Safety Certificate can be referred to in a number of ways which includes Landlord Gas Safety Record ( LGSR) or CORGI PROFORMA 12 (CP12). The later dating back to when the official body for gas safety in the UK was CORGI. However, the official body is now known as Gas Safe, hence it’s now usually called a Gas Safety Certificate or something along that line. But regardless of whatever you choose to call it, as long as you reside in the UK, it’s crucial to know that if you need one as soon as possible. So how do know if you need a Gas Safety Certificate?

If you’re a homeowner with a property that you live in, you’re not required by the law to obtain a Gas Safety Certificate. There’s nothing like a homeowner’s gas safety certificate, however we’d recommend you subject all you gas appliances and pipework to yearly examinations to ensure they’re functioning properly and safely.

If you’re a landlord in the UK, you’re required by the law to get a Gas Safety Certificate to ensure your property is safe for your tenants. You must reach out to an approved Gas Safe engineer who’ll carry out annual checks on your appliances to ensure that they’re totally safe.

Are Electric Radiators Expensive To Run?

Just like many home additions, the running costs of electric radiators varies largely on a number of factors. Great number of electric radiators typically comes with an in built thermostat which is designed to turn itself off automatically when not in use in order to save energy.

However the energy provider’s set electricity charge tariff will also have a great influence on an electric radiator’s running cost. Let’s take a look at the running costs of an electric radiator!

A 600 Watt electric radiator ( on a standard electricity tariff) will usually have a running cost ranging between 4 to 6 pence each hour. However you should also take note that this scenario might change in situations whereby the electric radiator is not calling for heat the full 60 minutes of each hour. And this is more likely to be the situation as the thermostat is programmed in such a way that enables it to turn itself off immediately there’s an achievement of your required room temperature level - usually within 10 minutes from the time it was switched on. As a result of this, the running cost per hour of electric radiators will be greatly reduced to just about 1 to 2 pence.

It’s also important to note that enhancing the insulation of your home can go a long way to add to the heat retention value of each room. Consequently, the duration at which the electric radiator calls more heating will be significantly reduced, which in turn, implies a lower electricity bill.

Another key factor that can play a huge role in saving on your heating bills is the programming as well as usage of your electric radiators. Every radiator comes with an independent digital thermostat with a number of 24/7 programming options to help achieve maximum efficiency. When the radiator is properly set according to your lifestyle, you can save as much as 50 percent on your heating bills.

Coloured double glazing windows are more expensive than white ones, in general. uPVC is the cheapest material to use for double glazing, and white is the standard colour. But there are endless possibilities in terms of colours you can have, and they do come at additional cost.

Some people choose to have coloured double glazing that matches or opposes the colour of the exterior of their house. Another popular option is a woodgrain effect, which from a distance looks just like more expensive timber windows. The best thing about a wood effect is that you can have the stylish look of wooden windows without the maintenance, and they should last longer.

While coloured double glazing is more expensive than white ones, it doesn’t have to break the bank. The best thing to do is get in touch with a range of window companies and ask them to come round to give you a quote. They should be able to offer you brochures or links to websites of different brands of windows that offer coloured frames. From there, you can decide on the installers you liked most and the brand you preferred.

It’s worth bearing in mind that it’s not always best to go with the cheapest coloured windows. While there lots of good, inexpensive options out there, sometimes very cheap windows won’t be good quality and may not last as long as other slightly more expensive brands. Speak to your installer about guarantees that may come with the windows and how long they would expect them to last before making your final decision.

A construction professional trained in putting up platforms and scaffolds is known as a scaffolder. These individuals can erect scaffolds related to building construction, and they can also work on offshore oil rigs, power stations, and projects such as parade viewing platforms. The pay is typically low, because the work is fairly basic, although those who specialize in more complex types of jobs may be able to obtain better salaries.

Being a scaffolder is not as easy as it sounds. The person will have to be a high school graduate and physically fit. It is also helpful if you are not afraid of heights. Training for this provided during the job while hard workers and fast learners get the chance at an early promotion.

The first step involves finding out the requirement and coming up with a plan. Scaffolds are generally made of metal and uses clips to snap into place. This allows fluid configuration of the scaffold structure as per needs. Wood is also sometimes used. After the scaffolding is set up, platforms are made to walk and hold tools. Safety nets and other safety measures should also be kept in place in some cases. After completing the job, the scaffolds can be easily dismantled and moved.

Construction of new buildings or renovation of any structure will utilise scaffolds. A skilled scaffolder can work as part of a team of people to put up a stable, well-anchored scaffolding that may stay up for weeks, months, or years, depending on the job. Periodically the scaffold needs to be reconfigured based on the need of the progress of the work. This is also particularly true in cases of restoration to avoid any sort of damage to the structures underneath the scaffolding. Scaffolders need to keep up with the restoration or the construction and periodically adjust the scaffolds as necessary.

Whether you’re liable for a leaking roof in a commercial property will depend on your ownership status and any contracts. Of course, if you own a standalone commercial property, it would make it your responsibility to repair to leaking roof. But if you own an office within a building, you should check your paperwork to see whether you are responsible for some or all of a leaking roof.

If you’re a tenant in a commercial property, things get a bit more complicated. Lots of commercial leases are FRI, or Full Repairing and Insuring leases, which means that the tenant is responsible for all external and internal maintenance and insuring the building. It means that it’s vital that you read through your tenancy agreement in full before signing it and seek legal advice if you think you need it. If your lease is an FRI lease, you are liable for a leaking roof in your commercial property.

It’s important to ensure that you have a schedule of condition for the property, which will mean that you only have to restore the commercial property back to the condition that it was in when you took over. It’s also worth getting the roof inspected before you sign the lease, as if there is any damage before you sign the landlord may be responsible.

The best way to avoid having to pay for a leaking roof in a commercial property is prevention. If you are liable for repairs and maintenance, make sure you have the roof inspected regularly by a reputable company to avoid having to pay for costly repairs when disaster strikes.