- Prepare the base If you want your resin bound driveway to last a long time, you need to ensure that you prepare the base properly. Remove any block paving, grass or soil and dig down until you hit solid ground. Lay a sub-base of asphalt for good permeability. If you’re laying over the top of your current driveway, make sure that all cracks are increased into a ‘v’ shape with a saw and ensure the surface is dry and weed-free.
- Mix the resin You must follow the instructions on the materials you have to the letter if you want the curing process to work. Usually batches come in ‘Part A’ and ‘Part B’. Keep the resin container secure and on a protective surface to avoid splashing, then mix Part A for 10-20 seconds at a slow speed with a helical bladed mixer. Add Part B and mix thoroughly at a slow speed for about 2 minutes until it’s blended together.
- Mix the dried aggregates and sand with the resin Place a quarter of the aggregates into a mixer, then add the pre-mixed resin and start a stopwatch. You should then add the rest of the aggregates before slowly adding the sand. When you’re happy with that mix, stop the stopwatch. That time is the time that you need to spend mixing any other resin and aggregates to avoid colour variation.
- Lay the mix on the surface Transfer the mix to the work area then plan a laying route. When the mix is laid out, use a very clean trowel to spread the mix. Clean it regularly during the process to avoid dragging aggregates out of place. Once the aggregates stop moving in a fluid movement and become solid, stop trowelling. Then you can polish the surface to give it an attractive shine.
Isle Of Cumbrae
Great Cumbrae (also known as Great Cumbrae Island, Cumbrae or the Isle of Cumbrae) is the bigger of both islands referred to as The Cumbraes in the reduced Firth of Clyde in western Scotland. House to the National Watersports Centre, the Cathedral of the Isles and also the College Marine Biological Station, Millport, the holiday island has an 18-hole fairway which sweeps virtually to the summit, and also a round-island road much favoured for household cycle runs. The island is about 4 kilometres (2.5 mi) long by 2 kilometres (1.2 mi) wide, rising to a height of 127 metres (417 ft) over water level at "The Glaid Stone" - a huge, normally occurring rock set down on the highest possible summit on the island. There is a triangulation pillar close by, as well as a positioning factor which suggests the places of surrounding landmarks. Millport, the island's only community, is spread around a bay which makes up the entire south shore of the island. The typical island population of 1,376 as recorded by the 2011 census was a small loss from the 2001 number of 1,434. The population enhances substantially during the summer season visitor season because of the high proportion of second houses.
